Brand
Samsung
Material
Steel
Finish
Baked-On Powder-Coated/Galvanized
Frequency Rating
60
Phase
1
Power Rating
125
Drive Type
Inverter
Refrigerant Type
R-410A
Cooling BTU Rating
11000 to 30000
Heating BTU Rating
7500 to 35000
EER Rating
11
SEER Rating
18
Compressor Type
Twin BLDC Rotary
Fuse Rating
30
HSPF Rating
10
Liquid Line Size
3/8
Suction Line Size
5/8 to 7/8
Number of Fan Speeds
3
Heating CFM Rating
2684
Cooling CFM Rating
2684
Heating Sound Level
52
Cooling Sound Level
50
Heating Operating Temperature
-13 to 75
Cooling Operating Temperature
23 to 125
Voltage Rating
208 to 230V
Amperage Rating
24.1A
Long Description
Samsung Hylex™ Inverter Driven Heat Pump Condensing Unit, 208 to 230 V, 24.1 A, 125 W Power, 60 Hz Frequency, 1 ph, Number of Fan Speeds: 3, Heating BTU Rating: 7500 to 35000 Btu/hr, Cooling BTU Rating: 11000 to 30000 Btu/hr, Heating CFM Rating: 2684 cfm, Cooling CFM Rating: 2684 cfm, 11 EER, 18 SEER, 10 HSPF, Twin BLDC Rotary Compressor, R-410A Refrigerant, 3/8 in Liquid Line, 5/8 to 7/8 in Suction Line, 30 A Fuse, Inverter Drive, Heating Sound Level: 52 dB, Cooling Sound Level: 50 dB, Steel, Baked-On Powder-Coated/Galvanized, Heating Operating Temperature: -13 to 75 deg F, Cooling Operating Temperature: 23 to 125 deg F, 37 in Overall Width, 39-5/16 in Overall Height, Additional Information: 13 in D
- Inverter driven heat pump condensing unit compatible with air handling units and A coils with a thermostatic expansion valve
- 100% rated heating capacity at 5 deg F outside temperature (refer to capacity tables in outdoor unit technical data book for full capacity details)
- Soft start compressor minimizing current inrush
- Base pan heater equipped as standard
- The condensing unit heat exchanger salt spray test method ISO 9227
- The heat exchanger showed no unusual rust or corrosion development to 3000 hr
- The system (outdoor unit with MXD-U000XN AHU control unit) shall provide three-fan speed control of the indoor unit increasing performance and dehumidification
- Refrigerant pipe connections and service ports are located inside the heat pump cabinet
- Refrigerant pipes can enter the cabinet on the front, side, back or bottom
- Requires MXD-U000XN AHU control unit (purchased separately) installed near the indoor unit for operation
- Control wiring shall be 2 x 18 AWG
- Compatible with standard 24 V thermostats
- Requires B reversing valve signal (24 V energized for heating)
- The compressor shall be hermetically sealed, inverter controlled, BLDC rotary
- The outdoor unit heat exchanger shall be mechanically bonded aluminum fin to copper tube
- Uses traditional unitary line sets (liquid pipe does not require insulation)
- Flexible pipe diameter compatibility (three suction pipe diameter options)
- Refrigerant flow shall be controlled by an electronic expansion valve in the outdoor unit for heating operation
- Refrigerant flow for cooling shall be controlled via thermostatic
- Expansion valve (TXV) at the indoor coil (bleed or non-bleed)